Drška svrdla za ugradnju Eagle Tool US ET18721, koristi se s izmjenjivim glavama bitova, 3/16-inča x 21-inča, proizvedeno u SAD-u 3/16 inča. 21 inča.

Name: Drška svrdla za ugradnju Eagle Tool US ET18721, koristi se s izmjenjivim glavama bitova, 3/16-inča x 21-inča, proizvedeno u SAD-u 3/16 inča. 21 inča.
Brand: Eagle Tool US
SKU: 0850078004116
Price: 45.51 EUR
Availability: InStock

Brand:Eagle Tool US

3.9/5

€
45.51

Eagle Tool individualne veličine, fleksibilni držači od opružnog čelika. Fleksibilne drške od opružnog čelika dolaze s rupama za smještaj ribe, tri ravna, neklizajuća držača stezne glave i brušenim neklizajućim urezom za izmjenjivu glavu. Otvor za pecanje žice na kraju stezne glave. Drška ima promjer 3/16 inča i duljinu od 21 inča.

Iznos

Dodaj u košaricu Kupi sada

EAN: 0850078004116

Kategorije Alati i poboljšanje doma, Električni i ručni alati, Dijelovi i pribor za električne alate, Dijelovi i pribor za bušilice, Svrdla, Montažna svrdla,

Zamjenjivi set vijaka i imbus ključeva ETAKIT2. Otvor za pecanje žice na kraju stezne glave. Neklizajući ravni (kraj svrdla) i neklizajući trostruki ravni držač (zatezna strana). Fleksibilna drška od opružnog čelika. Za korištenje s glavama ETS375, ETS562, ETH375, ETM375 i produžnim adapterom ETHXKIT187.

Brand	Eagle Tool US
Country of Origin	USA
Cutting Angle String	135 Degrees
Domestic Shipping	Item can be shipped within U.S.
Finish Type	Black Oxide
International Shipping	This item can be shipped to select countries outside of the U.S.
Item model number	ET18721
Manufacturer	Eagle Tool US
Material	Alloy Steel
Shank Type	Round

5 Star

4 Star

3 Star

2 Star

1 Star

Napišite svoju recenziju

Vaš email neće biti objavljen. Sva obavezna polja označena su s^*

Vaša ocjena

Scritto da: Amazon Customer

Much better than single piece design

I have a business that provides low-voltage installation services. I greatly prefer an interchangeable setup like this over single piece (bit plus shaft design). With the single piece once you dull the bit you have to replace the entire thing (at $30-50 a pop), not to mention you end up needing 4-8 different bits to accommodate different drill bit sizes and lengths. It is easy to attach a new bit and the lip design helps prevent the bit from spinning loosely. The reason for 4 stars is because you have to really make sure to get the screws tight on this otherwise you end up with a bit stuck inside the wall. FYI the 90 degrees is for the entire length of the rod, dont expect to make a 1" hole and bend this at a sharp 90 degree angle. Also the larger the drill bit the slower you should go with your drill. If you try to push a 3/4" bit through a double 2x4 header at max speed you will likely break the rod before you drill through.

Scritto da: Jarrod Major

A decent size for those hard-to-reach places

Pretty simple tool, not much to say, it does the job. 1/4" shank is very rigid. Like the convenient hole on the drill side for wire pulls.